Brief descript ion of mainboard
Installing/removing main m emory
Technical d a ta
Technology
DDR2 667/800 SDRAM unbuffered DIMM modules 240-Pin; 1.8 V;
64 Bit, no ECC
Total size
512 Mbytes to 16 G byte DDR2
Module size 512, 1024, 2048 or 4096 MByte per module
A current list of the memory m
odules recommended for this mainboard is available
on the Internet at: "
http://
ts.fuj itsu.com/mainboards ".
At least one memory module mu
st be installed. Memory modu les with different
memory capacities can be com
bined.
You m ay use only unbuffered
1.8 V memory modules without ECC.
DDR2-memory modules must
meet the PC2-5300U (CL5-5-5) or
PC2-6400U (CL6-6-6) spe
cification.
If you use more than one memory module, make sure to distribute the
memory modules over bo th memory channels. By doing this you use the
performance advantages of the dual-channel mode.
Maximum system performance is achieve d when identical memory modules
are used in Channel A and Channel B.
To simplify equipping, the slots are colour coded.
If you are plugging in the memory modules, start with the slot which
is located beside the processor (slot 1).
Channel B
slot 4
slot 2
Channel A
slot 3
slot 1
Number o f memory m od ules inserted
Slot to be used 1 2 3 4
Channel A, Slot 1
xxxx
Channel B, Slot 2
xxx
Channel A, Slot 3
xx
Channel B, Slot 4
x
The installation/removal is described in the "Basic informa tion on mainboard" manual.
4 - English A26361-D2831-Z 212-1-8N 19, edition 1
To Next Page
Loading...
Need help?
General
