To Next Page

To Previous Page

1-4. Setting the Remote controller custom code

(Only for wireless remote controller)

The indoor unit custom code can be changed.

Select the appropriate custom code.

( Factory setting)

Setting DescriptionFunction Number Setting Value

1-5. Setting the External input control

"Operation /Stop" mode or "Forced stop" mode can be selected.

( Factory setting)

Setting DescriptionFunction Number Setting Value

Operation / Stop mode

(Setting prohibited)

Forced stop mode

1-6. Setting the Room temperature sensor switching (Aux.)

To use the temperature sensor on the wired remote controller only,

change the setting to "Wired remote controller" (01).

This function will only work if the function setting 42 is set at "Both" (01)

)

Setting DescriptionFunction Number Setting Value

Both

Wired remote controller

( Factory setting

03-02

Fujitsu R410A Service Instruction

Other manuals for Fujitsu R410A