3-24
3
Using the NI / 5E Custom Terminal Set-Up
Selecting CA
Preference
•
Ringing line preference. Selects the CA button
that is ringing with an incoming call. If you
have more than one incoming call, the terminal
selects any ringing Intercom or Intercom Group
feature button first, and then selects the button
with the call that has been ringing the longest.
You are immediately connected to the call.
•
Idle preference. Selects a CA button that is
idle, if one is available.
If you have no incoming calls, the terminal selects
the idle CA with the lowest button number and
gives you a dial tone.
To select a CA preference, follow these steps:
1.
OPTIONS
11 ENTER
CURRENT MODE IS
PRIMARY
2.
ENTER
1: RINGING 2: IDLE
3: PRIMARY(SELECT 1-4)
NEXT
4: NO PREF
(SELECT 1-4)
3. Press the desired preference number, then
ENTER.
SUPPORTED
NI ONLY
To Next Page
Loading...