En-2
(5) Pull the front panel forward raising the upper surface, to
remove the front panel.
Front
panel
(6) Remove 2 screws, then remove the control box cover.
Control box
cover
Screw
Screw
3. INSTALLATION WORK
3.1. Front panel, control box cover removal
(1) Open the intake grille. While gently pressing the left and
right mounting shafts of the intake grille outward “a”,
remove the intake grille in direction of the arrow “b”.
Intake grill removal
b
a
(2) Remove 4 caps.
(3) Remove wire cover screw, then remove the wire cover.
(4) Remove 10 screws.
Wire cover screw
Screws
(10 places)
Caps (4 places)
Wire cover
3.2. Installing the terminal block
(1) Attach the terminal block to the indoor unit firmly with 1 screw (M4x25, accessory).
(2) Place the wiring as per the figure.
Place the wires from the terminal
block under the other wires.
(Front view)
Terminal block (with wire)
(Rightside view)
Place wire under the tab.
Indoor unit main PCB
Screw (M4x25)
(accessory)
9380828068_IM_EN.indd 29380828068_IM_EN.indd 2 11/11/2015 1:30:35 PM11/11/2015 1:30:35 PM
To Next Page
Loading...
