FULBAT - www.fulbat.com 3
attempting to charge any severely discharged or heavily sulfated
battery. Once the charger is timed-out, the charger will stop charging
for protecting your battery and the RED LED will be slow FLASH, while
this situation occurs, please check with your battery statues.
•
Reverse polarity: The charger has reverse battery protection. If a
reverse battery exists (Red LED ON, while output leads are connected
backwards), simply unplug charger from AC power and properly
remake the connections as described in this manual.
•
Short circuit protection: The charger has output short-circuit pro-
tection. If the charger output lead short condition exists (Red LED ON,
while output leads are connected backwards), simply unplug charger
from AC power and properly remake the connections as described
in this manual. The charger employs the rm hardware and smart
program to automatically detect the output connections. Once the
charger detects the output short-circuit or reverse polarity, it will
not deliver any output current.
BATTERY TYPES & CAPACITY
• Suits all Lead Acid Type Batteries. (GEL, SLA, AGM, Calcium).
• 12 Volt Output, Charging current 1500mA.
•
Battery Capacity: The following maximum Ah capacities are
to be used as a general guide only: some batteries may be
able to handle a higher Charge Current. Check with the batte-
ry Manufacturer when charging batteries with small capacity.
Charge current 1500mA
Battery Capacity: charging 4-30Ah
Battery Capacity: maintaining 4-120Ah
ELECTRICAL PARTS
Delivered with:
• A.C Power Cord:
- 6 feet with VDE Plug
• Output Lead:
- 4 feet with Trailer Connector
• Extension Cord:
- 2 feet with Trailer Connector + Battery Clamp or
- 2 feet with Trailer Connector + Ring Connector
ENVIRONMENTAL CHARACTERISTICS
• Operating Temperature: 0 to 40° C
• Storage Temperature: -10 to 80°C
• Operating Humidity Range: 90% RH Max
TECHNICAL SPECIFICATIONS
Part number Fulload 1500
Type Intelligent
Approvals CE
Input voltage range 100-240Vac
Input frequency 50/60Hz
Output 1.5A @ 12V
Size (LxWxH) in mm 109x71x29
Weight 0.45Kg
CHARGING INSTRUCTIONS
STEP 1 - Pre Charge Check & Electrolyte Level Check
• Check the Battery Electrolyte level (Not required on sealed & Main-
tenance Free Batteries).
•
If necessary, remove the vent caps and add distilled water so the
levels are halfway between the upper and lower ll lines.
STEP 2 - Connecting the Battery charger to your Battery
• If the Battery is out of the vehicle:
-
Connect the Red lead from the charger to the positive (+) battery
terminal.
-
Connect the Black lead from the charger to the negative (-) battery
terminal.
• If Battery is still in the vehicle, determine if the vehicle is positively
or negatively earthed.
•
If Negatively Earthed (Most Common) – FIRST Connect the Red (+)
battery charger lead to the positive (+) Battery post and then connect
the Black (-) battery charger lead to the vehicle’s chassis and away
from the fuel line.
To Next Page
Loading...
