What to do if my Full Boar Drill rotary hammer is not working?
If your Full Boar rotary hammer drill isn't working, first ensure that it's properly connected to a working power outlet. If the power supply is fine, check the mode selectors and make sure they are in the correct position by referring to the ‘Operating The Hammer Drill’ section in the manual.
Why is the hammer function not engaging on my Full Boar Drill?
If the hammer function on your Full Boar Drill isn't engaging, it might be due to excess grease. Try inserting an SDS-plus accessory, setting both modes to hammer function, turning the drill on, and firmly tapping the accessory bit up and down onto a scrap piece of material to activate it. Alternatively, the motor brushes might be binding; clean the brush holders by using compressed air to remove carbon dust.
What to do if I see excessive sparking through the air vents of my Full Boar Drill?
If you notice excessive sparking through the air vents of your Full Boar Drill, it's likely that the carbon brushes have worn out. Replace them according to the maintenance section.
To Next Page
General