To Next PageTo Next PageWhy my Full Boar H6033FB Log Splitter engine will not start?
If the Full Boar Log Splitter engine won't start, first ensure the engine switch and fuel shut-off valve are in the ON position. Check if the fuel tank is empty and fill it if needed. Make sure the spark plug is connected and not faulty; replace it if necessary. Also, adjust the choke lever position. If none of these steps work, there may be a faulty engine.
How to fix slow wedge movement on Full Boar H6033FB Log Splitter?
If the wedge movement on your Full Boar Log Splitter is slow or erratic, it might be due to air in the hydraulic oil system. Try purging the air by extending and retracting the wedge several times until the motion becomes smooth. Also, check for and clear any debris lodged in the beam guides. Finally, ensure that the hydraulic oil level is sufficient and add more if needed.
What to do if Full Boar Log Splitter has oil leak from cylinder?
If there is an oil leak from the cylinder of your Full Boar Log Splitter, check if any hydraulic fittings are loose and tighten them. For other potential causes such as a faulty cylinder rod seal, scored or bent cylinder rod, or a faulty combination washer seal on the cylinder hydraulic fitting, contact customer service.
General| Brand | Full Boar |
|---|---|
| Model | H6033FB |
| Category | Log Splitter |
| Language | English |
