FULTON ModSync SE User Manual

Questions? Please Contact Your Local Manufacturer’s Representative
SECTION 1 ModSyncSE-User-Manual-211020 INTRODUCTION
1-3
 Alarm Status
Boiler alarm status is monitored and annunciated via an Alarm Screen,
minimizing troubleshooting time requirements.
 Alarm History
Alarm History screen provides Date, Time, and Fault information from previous
alarm occurrences.
 BMS System Interface
Remote Enable/Disable contacts and Domestic Hot Water priority digital inputs
provide standard BMS interface capabilities.
 Firing Rate Tuning
Boiler ring rate will automatically be adjusted to prevent high limit faults in
variable ow applications.
 Auto/Manual Mode Control
The ModSync® can be congured for Automatic or Manual control of the boilers.
The Manual features help to decrease the boiler commissioning time by assisting
with verication of the communication interface.
 Warm Standby
If a boiler has not run or received a call for heat recently it will be enabled at low
re for a user dened amount of time.
 Transition Delay
If a rotation occurs and there is already a Lead Boiler it would delay shutting o
the running boiler(s) until the new boilers are released to modulate for a user
dened period of time (‘Delay’ time) and can optionally be left enabled until a
certain setpoint is met to prevent a drop in temperature.
 Boiler Isolation Valve Control
The ModSync® can be congured to control the boiler isolation valves. The
ModSync® will keep the lead boiler’s isolation valve open at all times to provide
a continuous ow path. A lag boiler’s isolation valve will be opened when the
boiler is called to run and will remain open until a user dened timeframe elapses
after the boiler is disabled. If isolation valves are selected, boiler pumps will be
unavailable.
! WARNING
This manual is provided as a
guide to the correct operation and
maintenance of your equipment,
and should be read in its entirety and
be made permanently available to
the sta responsible for equipment
operation. It should not, however
be considered as a complete code
of practice, nor should it replace
existing codes or standards which
may be applicable. Fulton reserves
the right to change any part of
this installation, operation and
maintenance manual without notice.
Do not install, operate, service,
or repair any component of this
equipment unless you are qualied
and fully understand all requirements
and procedures.
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional /professional codes or
regulations.

FULTON ModSync SE Specifications

General

Brand	FULTON
Model	ModSync SE
Category	Controller
Language	English