Cleaning the Inflatable
Clean inside debris/trash
with a shop vacuum.
Clean inside and outside using
damp rag.
If inflatable has stains, use
cleaning solution.
Disinfect the inflatable after
every use.
Keep your inflatable looking and performing like new by cleaning it thoroughly. If inflatable is
wet, DO NOT store away for an extended period, as this will cause mold and mildew and permanently
damage the fabric. Make sure to thoroughly dry wet inflatable within three days. Follow the steps
below:
Inflatable Maintenance
•
Inspect for signs of fabric failure; weak or
torn surfaces must be repaired promptly.
As an outdoor product, the bouncer is subject to
wear and deterioration.
•
To keep the product clean: wipe the bouncer
or blower using a dry cloth or a cloth dampened
with a neutral, non-flammable, non-toxic
cleaning and sanitizing solution or pure water.
•
Product should be periodically examined
for potentially unsafe conditions such as:
damaged cord, plug, housing, or parts, and
that in the event such damage is found, the
product should not be used until properly
repaired. Never leave the fan outside in the
rain or elements when not in use. Minor
repairs can be made using the enclosed
repair patches.
•
Store the blower upright on a stable surface.
•
Loosely coil the cord and place it beside the
blower.
•
When in use, do not place the cord across
traffic areas, water, or damp areas.
•
The blower is a high volume blower, and is
capable of moving large volumes of air very
quickly. Place the blower in an area where it
will not draw in dirt or leaves.
•
Do not operate any fan with a damaged
cord or plug. Discard fan or return to an
authorized service facility for examination
and/or repair.
•
Do not run cord under carpeting. Do not
cover cord with throw rug, runners, or similar
coverings. Do not route cord under furniture
or appliances. Arrange cord away from traffic
area and where it will not be tripped over.
•
Blower must be unplugged before servicing.
•
Product should be periodically examined
for potentially unsafe conditions such as
damaged cord, plug, housing, or parts, and
that in the event such damage is found, the
product should not be used until properly
repaired. If these checks are not carried out,
the product could overturn or otherwise
become a hazard.
•
The blower does not require any lubrication
and has no user serviceable parts. Do not
attempt to service the blower.
•
Do not immerse the fan in water. To clean,
wipe with a damp cloth.
•
Regularly check the intake and output
openings and keep free of dirt, leaves. etc.
•
When not in use, store the blower indoors in
a dry place.
Blower Maintenance
1 2 3
11
To Next Page
Loading...