26
Basic configuration
Please follow carefully these next steps, and always remove your propellers when you’re configuring
your quad
STEP 1: Connect Fortini F4 OSD with computer via USB cable and then open BetaFlight
STEP 2: Configure Ports.
(1) Configure Receiver:
With TBS Crossfire Receiver: Turn on Serial Rx of UART 1 to use Receiver Mode
With RX Serial:
- Turn on Serial Rx of UART 3 to use Receiver Mode
- Select SmartPort of UART 6 to use S.Port TX 6
(2) In Peripherals of UART 4:
Select IRC Tramp for Tramp HV VTx and Stealth Race VTx
To Next Page
Loading...
