Need help?Do you have a question about the Furman PB-48 and is the answer not in the manual?
General| Outlets | 8 |
|---|---|
| Amperage | 15 A |
| Spike Protection | Yes |
| EMI/RFI Filtration | Yes |
| Maximum Current | 15 A |
| Surge Protection | Yes |
| Input Voltage | 120 VAC |
| Output Voltage | 120 VAC |
| Dimensions | 1.75 x 19 x 7.5" |
| Mounting | Rackmount |
| Rack Units | 1 RU |
Overview of the Furman PB-48/PB-48D Patch Bay as a versatile, rugged, high-quality audio system accessory.
Explains the physical layout of PB-48 jacks and the signal flow from front to rear panel connections.
Describes how the PB-48 is factory-set as half-normalled, allowing signal splits without breaking the normal connection.
Explains the non-normalled setup where front panel jacks are only connected to their corresponding rear panel jacks.
Details the full-normalled setup, noting it's rare and not possible with PB-48's top jack design.
Provides practical examples of using the patch bay for inserting equipment and routing signals.
Step-by-step guide on how to convert patch bay pairs to the non-normalled configuration for PB-48 and PB-48D.
Explains how to wire multiple jacks together to create a 'mult' for signal distribution.
Instructions for mounting the PB-48 unit in a standard 19-inch equipment rack.
Details Furman's available patch cord styles, sizes, and ordering information.
Information on the three-year limited warranty for the PB-48 and PB-48D units.
Guidelines for returning equipment for repair, including obtaining an RA number and packing instructions.
Diagram illustrating the internal connections of a single vertical pair for the PB-48D model.
To Next Page