PB-48 PATCH BAY SYSTEM
9
Installing the PB-48
The PB-48 is intended for mounting in a standard 19" equipment rack. A logi-
cal spot to install it would be near the majority of the equipment to which it con-
nects, to minimize cable lengths. Standard racks come equipped with mounting
rails with holes tapped for 10-32 machine screws. Be sure to use only 10-32 screws
(in particular, avoid 10-24 screws, which will fit if forced but will strip the threads).
To avoid marring the panel when tightening the screws, use nylon washers under
the screw heads.
Patch Cords
Furman supplies its Patch Bay users better quality, highly flexible patch cords
in six styles at extremely low prices. They may be used for either front panel patch-
ing or rear panel interconnections. The prices quoted below are for sets of ten
cords. Prices include UPS shipping to locations in the USA other than Alaska and
Hawaii. You can order them directly from Furman by mail, or by phone or fax using
your Visa or MasterCard. Our numbers are listed on the back cover of this booklet.
Please call between 8:00 a.m. and 5:00 p.m. Pacific Time.
PATCH-P 10 Patch Cords, 1/4" phone to 1/4" phone, 30 inch (75 cm) $15.95
PATCH-R 10 Patch Cords, RCA to RCA, 30 inch (75 cm)$15.95
PATCH-T 10 Patch Cords, TRS (stereo phone) to TRS,30 inch (75 cm) $19.95
PATCH-PP 10 Patch Cords, 1/4" phone to 1/4" phone, 72 inch (183 cm) $17.95
PATCH-PR 10 Patch Cords, 1/4" phone to RCA,72 inch (183 cm) $17.95
PATCH-RR 10 Patch Cords, RCA to RCA,72 inch (183 cm) $17.95
California residents must add 7.5% sales tax. Add shipping charges (if Alaska,
Hawaii, or outside USA)allow 1 lb. per set of 10.
Limited Warranty
The Furman PB-48 and PB-48D are warranted against failures due to defec-
tive parts or faulty workmanship for a period of three years after delivery to the
original owner. During this period, Furman will make any necessary repairs with-
out charge for parts or labor. Shipping charges to the factory or repair station must
be prepaid by the owner; return shipping charges (via UPS Ground) will be paid by
Furman.
This warranty applies only to the original owner and is not transferable. Also, it
does not apply to repairs done other than by the Furman factory or Authorized
Repair Stations.
To Next Page
Loading...