4. INSTALLATION
4-7
Fabricate these cables as below to connect to the receiver unit.
DPYC-1.5 (For external alarm)
100 mm
5 mm
Scrape the paint off the cable
where the cable contacts the cable clamp.
Vinyl sheath
Soldering
Vinyl wire
25 mm
TTYCS-1Q (For Navigator or INS)
100 mm
5 mm
Scrape the paint off the cable
where the cable contacts the cable clamp.
Vinyl sheath
Soldering
Shield
Vinyl wire
25 mm
DPYC-2.5 (For ship’s battery)
100 mm
5 mm
Scrape the paint off the cable
where the cable contacts the cable clamp.
Vinyl sheath
Crimp-on lug
(M4, local supply)
25 mm
How to use J402 and 403 connector
1. Insert the terminal opener (attached in the receiver unit) into the connector.
2. Insert a wire in terminal while pressing and holding the terminal opener.
3. Release the terminal opener. Pull wire to confirm that it is connected firmly.
Wire
Terminal opener
To Next Page
Loading...
