What to do if Furuno Marine Equipment cannot turn on?
If your Furuno Marine Equipment fails to power on, have a serviceman replace the blown fuse. Also, verify the battery provides the correct voltage output.
What to do if Furuno Marine Equipment recording is not proper for the external printer (NX-700B only)?
If the recording is not proper for the external printer, check the setting of Printer on the System menu. Also, check the printer cable, ensure the printer's power is on and its status is 'SELECT/READY', verify the printer is available, and confirm that paper is set properly.
What to do if Furuno Marine Equipment NAVTEX signal cannot be received?
If you are unable to receive a NAVTEX signal on your Furuno Marine Equipment, perform the diagnostic test. Also, check the broadcasting schedule, ensure the D-sub connector is firmly fastened, and verify the antenna cable is securely connected.
What to do if Furuno Marine Equipment paper feeds but no recording (NX-700A only)?
If the paper feeds but there is no recording, check that the correct thermal paper is being used.
What to do if Furuno Marine Equipment receives unwanted messages?
General| Type | NAVTEX Receiver |
|---|---|
| Power Supply | 12-24 VDC |
| Operating Temperature Range | -15°C to +55°C |
| Frequency | 490 kHz, 518 kHz, 4209.5 kHz |
| Display | LCD |
Explains how to operate the NAVTEX system, including auto mode and message saving.
Covers settings within the NAVTEX menu, such as Mask Mode, Auto Rcv Mask, and Local Channel.
Explains system settings like Warning Message Alarm, Signal Monitor, Key Beep, Time Offset, and Units.
Details display settings including Scrolling, Font Size, Time/Date Display, User Display, and Contrast.
Covers service settings like INS Input/Output Speed, Print Header, Edit Station List, and Test options.
Explains the connection overview for NX-700A and NX-700B, detailing port specifications.
Provides detailed block diagrams and descriptions of the receiver, display, and antenna units.
Outlines the step-by-step procedure for updating the NX-700 program, including PC connection and batch file execution.
Describes various self-test procedures including Key Test, LCD Test, RX Test, and memory checks.
Explains how to monitor received signals on audio frequency and view real-time reception status.
Details specific tests within the Initialize menus, such as System Test Results, View Nav Data, and Adjust Rx Unit.
Describes methods for clearing user settings, all settings, and received messages from the device.
Guides users on how to replace the CPU board battery and check its voltage status.
Provides diagnostic flowcharts and solutions for common issues like power failure, no reception, and printer problems.
To Next Page
