2.5 Setting of Service menu
2-23
2.5 Setting of Service menu
The contents of the service menu are same for the programs Ver-01.02 and Ver-02.01.
1. INS Input Speed (4800/9600/19200/38400)
This is the setting of the bit rate for serial data input of the INS port J402 of NX-7001
unit. Select “4800” when the data is inputted by IEC61162-1 sentences from the GPS.
When the INS is connected, set it according to the bit rate of the specifications of the
INS.
Related setting:
Program Ver-01.02: Select “INS” in [MENU] -> NAVTEX -> Receive Mode.
Program Ver-02.01: Select “INS” in [MENU] -> NAVTEX -> Mask Mode.
2. INS Output Speed (4800/9600/19200/38400)
This is the setting of the bit rate for serial data output of the INS port J402 of NX-7001
unit. When the INS is connected, set it according to the bit rate of the specifications of
the INS.
Related setting:
Program Ver-01.02: Select “INS” in [MENU] -> NAVTEX -> Receive Mode.
Program Ver-02.01: Select “Mask Mode” in [MENU] -> NAVTEX.
3. Print Header (On/Off)
This is the setting whether or not to print the header including the position information
and time.
Related setting:
[MENU] -> Display -> Time Display
[MENU] -> Display -> Date Display
[MENU] -> System -> Unit
Print Header
To Next Page
Loading...
