Furuno NX-700B - Preparation; Connection

6.1 Overview
6-2
6.1.3 Preparation
1. Connection
Prepare the cable to be connected between the serial port of the PC and the
[RECEIVER] port of the Display unit as shown below.
Fig. 6.1.1 Connection for updating NX-700 Program
Connect the cable
to this port.
Do not connect the cable
to this port.
PC
#3-TXD
#2-RXD
#5- GND
#14-RD
#11,23,24-DC(+)
#12,13,25-DC(-)
#1-SD
#22- GND
Serial Port RECEIVER
DC Power
(+12 - +24VDC)
NX-700B
25p D-sub
female
9p D-sub
female