Furuno NX-700B - Setting of Printer Μtp-58 E-FU; Default Setting of DIP SW; Switch Operation

2.8 Setting of printer µTP-58E-FU
2-31
2.8 Setting of printer µTP-58E-FU
2.8.1 Default setting of DIP SW
Do not change the configuration of DIP switches for setting the printer operation.
Fig. 2.8.1 DIP SW
Table 2.8.1 Default setting of DIP switches
DIP SW Pin No.
1 2 3 4 5 6 7 8 9 10
Setting OFF ON OFF OFF OFF ON OFF OFF ON OFF
2.8.2 Switch operation
Table 2.8.2 Functions of DIP switches
DIP SW Pin No. Function OFF ON
1 to 4
Communication
method
See Table 2.8.3.
5 Bit length 8 bits 7 bits
6 Control method RTS/CTS Xon/Xoff
7, 8 Command mode See Table 2.8.4.
9
Upright/ Inverted
printing
Upright printing
Inverted printing
10 Test pin Normal mode Setting disabled
DIP SW for operation
setting