1.2 Operation Guide
1-8
1.2.4 Operation Guide
1. Status display
518
ALL MESSAGES
x MESSAGE
I I L1 L2L1 L2
X
P
R
Icon
Status Meaning
I
Blinking
Shows that there is an unread message on the international frequency
(518 kHz).
L1
Blinking
L2
Blinking
Shows that there is an unread message on the local frequency
(L1: 490 kHz, L2: 4209.5 kHz).
I
Blinking
L1
Blinking
L2
Blinking
Shows that a message is being received.
I: International frequency (518 kHz), L1: Local frequency (490 kHz)
L2: Local frequency (4209.5 kHz)
In the Russia mode, an icon corresponding to the selected frequency lighting.
Lighting
Shows that the voltage of the battery for backup of memory (SRAM) goes
down below +2.5 VDC. The display also shows a popup message as “Battery
error”. When this error message is displayed, replace the lithium battery of the
CPU board. Voltage adequate for SRAM (received message) backup is
+1.8 VDC or more.
Related setting:
[MENU] -> Service -> Test: Battery
X
Lighting
Detects “PE” signals outputted from the printer.
Printer error: Displayed when paper runs out or printer door open is detected.
The display also shows a popup message as “Printer error”.
P
R
Lighting
Shows that printing is under way.
Related setting:
[PRINT]
[MENU] -> NAVTEX -> Printer Mask (Ver.02.01)
[MENU] -> System -> Printer
DEMO
Lighting
Shows that the status is in the DEMO mode.
To enter this mode, select “ON” in [MENU] -> Initialize1 -> Demo.
The received frequency is switched by
the [<] and [ [>] keys among 518 kHz,
490 kHz or 4209.5 kHz.
elated setting:
[MENU] -> NAVTEX -> Local Channel
The number of selected received messages.
Up to 200 messages are stored for two
frequencies, respectively.
Fig. 1.2.4 Status display
DEMO
Selection of received message
elated setting:
Select messages on the [LIST] menu.
- All Message
- Alarm Message: A, B, D, L
- User Select Message:
* [MENU] -> Display ->
User Select & Msg *
- Good Message:
* Message whose error rate is 4 %
or less. *
- Lock Message (Unlock Message)
To Next Page
Loading...
