What to do if Furuno Marine Equipment cannot turn on?
If your Furuno Marine Equipment fails to power on, have a serviceman replace the blown fuse. Also, verify the battery provides the correct voltage output.
What to do if Furuno Marine Equipment recording is not proper for the external printer (NX-700B only)?
If the recording is not proper for the external printer, check the setting of Printer on the System menu. Also, check the printer cable, ensure the printer's power is on and its status is 'SELECT/READY', verify the printer is available, and confirm that paper is set properly.
What to do if Furuno Marine Equipment NAVTEX signal cannot be received?
If you are unable to receive a NAVTEX signal on your Furuno Marine Equipment, perform the diagnostic test. Also, check the broadcasting schedule, ensure the D-sub connector is firmly fastened, and verify the antenna cable is securely connected.
What to do if Furuno Marine Equipment paper feeds but no recording (NX-700A only)?
If the paper feeds but there is no recording, check that the correct thermal paper is being used.
What to do if Furuno Marine Equipment receives unwanted messages?
General| Type | NAVTEX Receiver |
|---|---|
| Power Supply | 12-24 VDC |
| Operating Temperature Range | -15°C to +55°C |
| Frequency | 490 kHz, 518 kHz, 4209.5 kHz |
| Display | LCD |
To Next Page
