2.2 Setting of NAVTEX menu
2-8
2.2 Setting of NAVTEX menu
2.2.1 Program Ver-02.01
1. Mask Mode (INS/Manual)
Select whether to set: Mask of “Rcv Mask” on the NAVTEX menu manually or by the
command from the INS. To perform the setup manually, select “Manual”. In this case,
the Mask set command from the INS is disabled but the Nav data such as the position
data and Date/Time data are enabled. To enable the setup by the Mask set command,
select “INS”.
When “INS” is selected, the following items disappear and cannot be selected.
- ON/OFF of Auto mode:
[MENU] -> NAVTEX -> Auto Rcv Mask
- Setting of local frequency:
[MENU] -> NAVTEX -> Local Channel
Items that can be set from the INS are as follows. These items can be set through IEC
sentences from the INS.
- Setting of local frequency ($NMK)
[MENU] -> NAVTEX -> Local Channel
- Selection of receiving station and received message ($NMK)
[MENU] -> NAVTEX -> Rcv Mask
Related setting:
[MENU] -> NAVTEX -> Rcv Mask
[MENU] -> Service -> INS Input Speed
[MENU] -> Service -> INS Output Speed
To Next Page
Loading...
