7.3 Test in Initialize-1 and Initialize-2 menus
7-12
7.3 Test in Initialize-1 and Initialize-2 menus
7.3.1 Test in Initialize-1 menu
1. System Test Results
The System Test Results show the results of the factory test described in page 7-6.
Normally, all the results are shown as “OK”. The test results are stored in U13
(EEPROM) and not cleared even if “All Clear” is executed in “[MENU] -> Initialize1
-> All Clear”.
2. Initialize1 -> View Nav Data
This setting allows monitoring of IEC61162 sentences inputted between #4 (RD-A) and
#5 (RD-B) of the INS port J402 (WAGO) on NX-7001.
Note:
Check that the baud rate (speed) of the inputted sentence meets the setting in
“[MENU] -> Service -> INS Input Speed”. If the speeds do not match, the data
cannot be read correctly. As a result, is displayed.
Menu
NAVTEX
System
Display
Service
Initialize1
Initialize2
Initialize1
Delete All Msgs
All Clear
Dem Mode
System Test Results
View Nav Data
ZCZC Chaeck
00 Msg Priority
Print Order
Available Rcv Station List
Adjust Rx Unit
Rx Test
Off
On
Old -> New
00>B1>B2
VIEW NAV DATA
[MENU] RETURN TO MENU
I
L1
$GPZDA, 181052,25,08,2005,0 $G
PGLL ,3444.974,N,13454.969
[ENT] CLEAR
GLL ,3444.974,N,13454.969,E $GPR
View nav data ?
Yes No
Note;
Every time the [ENT] key is pressed,
the screen is updated.
To Next Page
Loading...
