7.5 Popup Message
7-17
7.5 Popup Message
When a certain event occurs, a user is notified of it on the popup massage display.
Table 7.5.1 Popup message list of handling of Received message
Popup of handling of received
message
Description
Received new local msg.
Display new msg ? Yes/No
This popup message is displayed when a new message is
received on the local frequency (490 kHz or 4209.5 kHz).
Related information:
Switching of frequency
[MENU] -> NAVTEX -> Local Channel
Received new int’l msg.
Display new msg ? Yes/No
This popup message is displayed when a new message is
received on the international frequency (518 kHz).
New message received.
Oldest message deleted to free up
memory.
This popup message is displayed when a new message is
received while the oldest received message is displayed with
the memory for received messages filled and the oldest
received message is deleted.
The memory capacity for received messages is up to 200
messages for the international frequency and local frequency,
respectively. Assuming the average number of characters of
one message to be 500 characters, the number of characters to
be stored is 200 × 500 = 100,000 for each frequency.
Same message with lower error rate
received. Currently displayed
message will be deleted.
This popup message is displayed when a message having the
same ID as an already stored received message is received
again, the newly received message has a lower error rate than
the previously received message, and the received message is
displayed. The displayed received message is replaced with
the new message. A received message with the error rate
between 4 % and 33 % (inclusive) can be stored.
Term of validity expired. Currently
displayed message will be deleted.
Shows the term of validity of a received message.
This popup message is displayed when 66 hours have elapsed
after a message was received and before the message is
deleted.
A received message which is protected by selecting “Lock
Message” on the [LIST] menu while the received message list
is displayed is not deleted.
Message not chosen for display
received; it is a int’l 00 message.
Choose “All Message”(LIST menu)
to display.
In reception on the international frequency;
1. When “Alarm Message (A/B/D/L)” is selected on the
[LIST] menu and an emergency message (ID = xx00)
other than alarm messages is received.
2. When “Non-display” is selected for the station or received
message in “[MENU] -> Display -> User Select Station &
Msg” and “User Select Message” is selected on the [LIST]
menu and an emergency message (ID = xx00) is received.
3. When “Good Message” is selected on the [LIST] menu and
when an emergency message (ID = xx00) with the error rate
of 4 % to 33 % is received.
Note:
To display the received message, select “All Message” on
the [LIST] menu.
To Next Page
Loading...
