Furuno PP-505-FE - Mounting Options and Wiring

5
3.3 Tabletop/Bulkhead Mount 3.4 Flush Mount
The main unit can be mounted on a desktop,
bulkhead, or in a panel. Make sure the
selected location is strong enough to support
the main unit against possible vibration and
shock. If necessary, appropriate
reinforcement measures should be made on
the mounting area.
Tabletop mount
1. Drill four pilot holes for the hanger.
2. Fix the hanger with the tapping screws
(5×20) supplied.
3. Place the unit in the hanger and tighten
knobs.
268
2.9 kg
107
141
Knob bolt
Hanger washer
0.2
Tapping screw
Flat washer
Hanger
90
60
120
200
480
Bulkhead mount
When the unit is installed on the bulkhead,
fix the hanger as shown below.
Flush mount panel kit is optionally supplied.
Flush mount kit OP08-4 (Code No.:
004-511-330)
Name Type Code No. Qty.
Flush
mount
panel
22-008-0125 100-103-351 1
Ta p p ing
screw
5x20 000-163-867-10 4
Nylon
washer
2.8x7x0.5 000-800-728 4
Pan
head
screw
M3x8 000-163-669-10 4
Hex.
bolt
M8x16 000-162-291-10 2
Flat
washer
M5 000-864-128 4
Flat
washer
M8 000-864-130 2
Spring
washer
M8 000-864-262 2
Rosette
washer
M3 000-864-900 4
Flush
mount
angle
22-008-0126 100-103-361-10 2
Liner 22-008-0127 100-103-371 2