Fusion Active Wedge CS-AW1120 User Manual

ACTIVE WEDGE
SPECIFICATIONS
 CS-AW1120 CS-AW2120
PeakPower(Watts) 450 750
RatedPower(Watts) 150 250
FrequencyResponse 34Hz-250Hz 34Hz-250Hz
LowPassFilter(Variable) 40Hz-250Hz 40Hz-250Hz
Tuning BassReex BassReex
WooferSize 12” Dual12”
Fuse 25A 25A
Dimensions(mm) 550(l)x408(w)x368(h) 820(l)x408(w)x368(h)
 21-21/32x16-1/32x14-15/32” 32-9/32x16-1/32x14-15/32”
CS-AW1120, CS-AW2120
www.fusionelectronics.com
CONTROL DESCRIPTIONS
LEVEL
Thisallowstheadjustmentoftheamplierlevelofthesubwoofer.
Turnclockwisetoincreasethelevel.Ifthesoundbecomesdistorted
reducethelevel.
LOW PASS FILTER (LPF)
This allows the adjustment of the highest frequency the Active
Wedgewillproduce.Thisshouldbeadjustedtoblendwithyourmain
speakers.Typically,thiswillbesettoaround100Hz(approximately
thecentralpositionofthecontrolknob).
REMOTE LEVEL CONTROLLER
Whenconnected,thisallowsfurthercontroloverthelevelfroma
remotelocation,usingthesuppliedlead.
INSTALLATION
MakesuretheActiveWedgeisrmlyxedinyourvehicle.Check
beforedrillingorcuttingholes.DONOTworkneargastanks,fuel
lines,hydrauliclinesorelectricalwiring.
DO NOT mount the Active Wedge in such a way as to pinch or
damagethewires.
Make sure everything is rmly connected, before attaching the
+12Vwire.Ensurethe+12Vwireisfusedascloseaspossibletothe
battery.Alwaysuseafusewiththerecommendedrating.
DISCLAIMER
AlwaysensuretheActiveWedgeissecurelyattached,toavoidmovement.FUSIONacceptsnoresponsibilityfordamageorinjuryinrelation
toinappropriatesecuringofthisproduct.
WIRING
• Connectthegroundwiretothevehiclerst(cleandirtandpaint
 tobaremetal).
• Connecttheremoteon(bluewire).
• ConnecttheRCAcablesifapplicable,OR
• Connectthespeakerlevelwirebysplicingintotheheadunits 
 speakerwires.SeeNote1onreverse.
• Connecttheremotelevelcontrollerwiththesuppliedlead.
• Connectthe12volt(redwire)tothepositivebatteryterminal. 
• Checkallconnections.

Fusion Active Wedge CS-AW1120 Specifications

General

Brand	Fusion
Model	Active Wedge CS-AW1120
Category	Car Stereo System
Language	English

Summary

Product Specifications

Disclaimer

Control Descriptions and Functions

Level Control

Adjusts the amplifier level of the subwoofer. Turn clockwise to increase level.

Low Pass Filter (LPF)

Adjusts the highest frequency to blend with main speakers, typically around 100Hz.

Remote Level Controller

Allows further control over the level from a remote location using the supplied lead.

Installation Guide

Wiring Instructions

Important Wiring Note

Safety Warnings