Fusion CS-CM50 - User Manual

COMPONENT SPEAKER SYSTEMS
 CS-CM50 CS-CM60
PeakPower(Watts) 220 240
RatedPower(Watts) 35 40
FrequencyResponse 41Hz-26kHz 35Hz-26kHz
Impedance 4Ohms 4Ohms
Sensitivity 85dB 86dB
ConeMaterial Polypropylene Polypropylene
Tweeter PEI PEI
MountingDepth 43mm(1-11/16”) 45.5mm(1-13/16”)
MountingDiameter 118mm 126mm
 (4-21/32”) (5”)
CS-CM50 CS-CM60
WARNING:Donotdrillmountingholeswithspeakerinplaceasthiscouldallowdrillshavingstodamagethe
voicecoilandvoidyourwarranty.
SPEAKER PARAMETERS
www.fusionelectronics.com
TWEETER
Ø53mm
(2-1/16”)
9mm(11/32”)
20mm(25/32”)
47mm
(1-27/32”)
INSTALLATION GUIDELINES
Ensuretheaudiosystemisturnedoffbeforemakinganyconnections
totheamplier,speakersorsourceunit.Failuretodosocouldresultin
permanentdamagetotheaudiosystem.
Whenwiringthespeakersensurethatthewireisprotectedfromsharp
objectsandalwaysuserubbergrommetswhenwiringthroughmetal
panels.Ensureallterminalsandconnectionsareprotectedfromthe
vehiclechassisandfromeachotherasfailuretodosocouldresultin
permanentdamagetotheaudiosystem.
Whenconnectingthesourceunitandspeakersensureyouconnect
thepositiveandnegativeoutputwirefromthesourceunittothe
correspondingspeakerterminals.Thiswillensuretheaudiosystemwill
beinphase.

1) Ensurethereisadequateclearance&depthforthespeakertobe
 mounted
2) Usethesuppliedtemplatetomarkout&cutthecorrectdiameterhole
3) Drillfourholesforthemountingscrews
4) Seperatethegrillefromtheframe
5) Insertthespeaker&grilleframeandafxwiththescrewsprovided
6) Completeinstallionbyreplacingthegrilleintothegrilleframe

Fusion CS-CM50 Specifications

General

Brand	Fusion
Model	CS-CM50
Category	Speaker System
Language	English

Summary

Speaker Parameters

Installation Guidelines and Warnings

Installation Steps

Numbered sequence for mounting speakers, including marking, drilling, and assembly.

Mounting Warning

Caution against drilling mounting holes with speaker in place to prevent damage.

Tweeter Mounting Options

Surface;Angle Mount Tweeter

Guidance on positioning and mounting the tweeter for optimal performance on a surface.

Flush Mount Tweeter

Instructions for flush mounting the tweeter, requiring a specific hole size and assembly.

Purchase Details and Information

Record Purchase Details

Section to log serial number and date of purchase for record-keeping.

Further Information

References website for additional product and installation information.