Problem Possible solution
Make sure that the appliance door is closed.
The appliance door does not close. Make sure that the installation of the filter is
correct.
Make sure that the laundry does not catch
between the appliance door and the rubber
seal.
The appliance stops during operation. Make sure that the water container is empty.
Press Départ/Pause (Start/Pause) to start
the programme again.
The cycle time is too long or unsatisfactory
drying result.
1)
Make sure that the weight of the laundry is
applicable to the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in
the washing machine again.
Ensure that the room temperature is higher
than +5°C and lower than +35°C. Optimal
room temperature is 19°C to 24°C.
Set the Minuterie (Time Drying) or the Extra
Sec (Extra Dry) programme.
2)
1)
After maximum 5 hours, the programme ends automatically.
2)
It can happen that some area remains humid when drying big items (e.g. bed sheets ).
If the drying results are not satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.
• There was too much laundry in the
appliance.
• The drum is dirty.
• Incorrect setting of the conductivity
sensor ( See chapter "
Settings -
Adjustment of the remaining laundry
moisture degree
" for better setting).
• The airflow slots are clogged.
• Room temperature is too low or too
high ( optimal room temperature 19°C
to 24°C )
TECHNICAL DATA
Height x Width x Depth 850 x 596 x 645 mm (maximal 669 mm)
Max. depth with the appliance door open 1104 mm
Max. width with the appliance door open 933,2 mm
Adjustable height 850 mm (+ 15 mm - feet regulation)
15
To Next Page
Loading...
