34
Something not working?
If a problem occurs, you can try to solve it yourself following the instructions below. If you call out an
engineer when one of the following problems occurs, or to repair a fault due to incorrect use, the
callout will be charged even if requested within the guarantee period.
Problem Possible cause Solution
The drier is not working
properly
• Mains plug disconnected Plug in mains plug
• The START button has not
been depressed.
• Press START button
• No programme selected • Select programme
• Loading door open • Close loading door
• Fuse or residual current cir-
cuit breaker in fuse box
(domestic installation) faulty
• Check fuse or residual cur-
rent circuit breaker. Faults
can be eliminated by an elec-
trical engineer
The drying results are not
satisfactory
• Wrong programme selected
• Select another (time) pro-
gramme for the next drying
cycle
• Lint filter blocked • Clean lint filter
• Wrong filling quantity
• Observe recommended filling
quantity
• Laundry not sufficiently dried • Pre-dry laundry sufficiently
• Deposit on the drum inner
surfaceor on the drum ribs
• Clean drum inner surface
and drum ribs
To Next Page
Loading...
