FUTABA 16SZ - Page 116

117
＜ Linkagemenu ＞
6HOHFWWKHRSHUDWLQJPRGHIRUHDFKFKDQQHO
 12507KHPRGHOLVFRQWUROOHGE\VLJQDOV
IURPWKHVWXGHQWWUDQVPLWWHU
 0,;PRGH7KHPRGHOLVFRQWUROOHGE\
VLJQDOVIURPWKHWHDFKHUDQGVWXGHQW
WUDQVPLWWHUV5HVHWWKHVWXGHQWVPRGHOGDWD
WRWKHGHIDXOWFRQGLWLRQ
 )81&PRGHIXQFWLRQPRGH
 7KHPRGHOLVFRQWUROOHGE\VLJQDOVIURP
WKHVWXGHQWWUDQVPLWWHUZLWKWKHWHDFKHU
$)5VHWWLQJ5HVHWWKHVWXGHQWVPRGHOGDWD
WRWKHGHIDXOWFRQGLWLRQ
 2))2QO\WKHWHDFKHUVLGHRSHUDWHV
*The setting above allows setting of the servo throw relative
to the amount of student side operation when [MIX] or
>)81&@ZDVVHOHFWHG
 :KHQFKDQJLQJWKHUDWHXVHWKHʈʈʈ
ʆʆʆEXWWRQWR7DSWKH>5DWH@LWHPRI
WKHFKDQQHO
 6HWWLQJUDQJHa
 ,QLWLDOYDOXH
*When the value is tapped, the rate is reset to the initial value.
6HWWKHVZLWFKRIHDFKFKDQQHO
*When setting the switch at each channel, tap to the "SW"
item of the channel you want to change, call the switch
setup screen, and select the switch.
 $OZD\V21
 6$a6+7KHVZLWFKZKLFKHQDEOHVVWXGHQW
VLGHRSHUDWLRQFDQEHVHOHFWHG6HH6ZLWFK
VHOHFWLRQPHWKRGDWWKHHQGRIWKLVPDQXDO
IRUVHOHFWLRQPHWKRGGHWDLOV
Trainer student channel setting function
In training mode, the instructor's transmitter can
pick up the student's signal on both the "Function"
DQG0L[FKDQQHOV7KDWPDNHVLWHDV\IRUWKH
two transmitters to connect even if the student and
instructor have set up their transmitters differently.
:KHQWKHLQVWUXFWRUVWUDQVPLWWHUPRGHLVVHWWR1250
the signal of the same channel of the student's transmitter is
RXWSXWDVLV7KHVDPHDVEHIRUH