FUTABA 16SZ - Page 31

32
＜ BeforeUse ＞
Link/Mode Switch
8VHWKHVPDOOSODVWLFVFUHZGULYHUWKDWZDV
LQFOXGHGZLWK\RXUUHFHLYHU
7KH/LQN0RGH6ZLWFKLVDOVRXVHGIRUWKH&+
mode selection.
Extra Voltage Connector
8VHWKLV
FRQQHFWRUZKHQXVLQJDYROWDJH
telemetry device to send the battery voltage (DC0
a9IURPWKHUHFHLYHUWRWKHWUDQVPLWWHU
<RXZLOOQHHGWRSXUFKDVHWKHRSWLRQDO([WHUQDO
9ROWDJHLQSXWFDEOH&$59,1)870
<RXFDQWKHQPDNHDFDEOHZLWKDQH[WUD
FRQQHFWRUWRWKH([WHUQDOYROWDJHFRQQHFWRU
Before using the receiver, be sure to read the
SUHFDXWLRQVOLVWHGLQWKHIROORZLQJSDJHV
ŵƈƆƈƌƙƈƕŃŵŚœœśŶť
Connector
"1 through 6": outputs for the channels 1
through 6
%RXWSXWVRIFKDQQHOVDQGSRZHU
"8/SB": outputs of 8 channels or S.BUS port.
[S.BUS Servo S.BUS Gyro ]
*When using 8/SB as S.BUS, you have to
set
&+02'(RIWKHIROORZLQJSDJHWRPRGH%RU
mode D.
"S.BUS2": outputs of S.BUS2 port.
[S.BUS2 Servo S.BUS2 Gyro Telemetry Sensor ]
*When using 9 or more channels, use an S
.BUS
IXQFWLRQRUXVHDVHFRQG56%DQGOLQN
both to your transmitter.
&*<6%86*\URVKRXOG127EH
connected to the S.BUS2 ports on any receiver.
Connector insertion
Firmly insert the connector in the direction
VKRZQLQWKH¿JXUH,QVHUWWKH6%86E\WXUQLQJ
it 90 degrees.
＋
−
'RQRWFRQQHFWHLWKHUDVZLWFK
RUEDWWHU\LQWKLVPDQQHU
'RQRWFRQQHFWHLWKHUDVZLWFK
RUEDWWHU\LQWKLVPDQQHU
5HFHLYHU
DANGERDANGER
DANGER
Don'tattachaconnectorasshownin
theprecedingillustration.
*Itwillshort-circuitifconnectedinthisway.A
shortcircuitacrossthebatteryterminalsmay
causeabnormalheating,fireandburns.
WARNING
S.BUS2connectors
Don'tconnectanS.BUSservo/gyro
toS.BUS2connector.
LED Monitor
This monitor is used to check the CH mode of
the receiver.
ŵƈƆƈƌƙƈƕŃƑƒƐƈƑƆƏƄƗƘƕƈ