FUTABA 16SZ - Page 38

39
＜ BeforeUse ＞
ŶőťŸŶŒŶőťŸŶŕŃƇƈƙƌƆƈŃƖƈƗƗƌƑƊ
S.BUS/S.BUS2 servos or a telemetry sensor can be connected directly to the T16SZ. Channel setting and
other data can be entered for the S.BUS/S.BUS2 servos or sensors.
6%866%86VHUYR
6%866%86
GHYLFH
:D\KXE
RU<KDUQHVVHV
5HFHLYHU
%DWWHU\
7HOHPHWU\VHQVRU
76=
&RQQHFWWKH6%86GHYLFHDQGEDWWHU\\RX
ZDQWWRVHWZLWKDZD\KXERU<KDUQHVVHV
DVVKRZQLQWKHÀJXUH
2. Turn on the transmitter power.
3.
Call the setup screen.
Servo: System Menu
ĺ
6%86VHUYR
Sensor: Linkage Menu
ĺ
Sensor
4. Perform setting in accordance with each
screen.
5. This sets the channel and other data for each
6%86
VHUYR
RUWHOHPHWU\GHYLFHWREHXVHG
ZLWKWKH6%86GHYLFHRUUHFHLYHU
WARNING
DonotdisconnectorturntransmitterpowerOFF
whileS.BUSservoandtelemetrysensordatais
beingsaved.
■ S.BUSservoandsensorsavedatawillbelost,
resultinginmalfunction.