FUTABA 16SZ - Page 64

65
＜ Linkagemenu ＞
The Linkage menu is made up of functions which
perform model addition, model type selection, end
point setting, and other model basic settings.
ŏ 6HOHFWWKHIXQFWLRQ
QDPHDQGUHWXUQWR
WKH+RPHVFUHHQ
ŏ7DSWKH>/LQNDJHPHQX@EXWWRQLQWKH+RPH
VFUHHQWRFDOOWKHVHWXSVFUHHQVKRZQEHORZ
ůƌƑƎƄƊƈŃƐƈƑƘŃƉƘƑƆƗƌƒƑƖŃƗƄƅƏƈ
[Servo monitor]: Displays the servo test and operation position
[Model select]: Model addition, call, deletion, copy, model name setting
[Model type]: Model type, wing type, tail type, swash type, selection
[Servo reverse]: Servo direction reversal
[End point]: Servo basic rate adjustment and limit setting
[Servo speed]: Servo speed setting
[Sub-trim]: Adjusts the neutral position of each servo
[Function]: Channel assignment of each function can be changed
[Fail safe]: Fail safe function and battery fail safe function setting
[System type]: System mode selection, link of a transmitter and receiver, telemetry mode selection
[Trim setting]: Control step amount and mode selection of the digital trim
[Throttle cut]: Stops the engine safely and easily
[Idle down]: Lowers the idle speed of the engine
>6ZDVKULQJ@/LPLWVWKHVZDVKSODWHWUDYHOWRZLWKLQD¿[HGUDQJHKHOLFRSWHURQO\
>6ZDVK@6ZDVK$)5DQGOLQNDJHFRUUHFWLRQIXQFWLRQKHOLFRSWHURQO\H[FHSWVZDVKW\SH+
[Stick alarm]: Can be set so that an audible alarm sounds when the throttle stick reaches the set position.
[Timer]: Timer setting
[Function name]: Function name can be changed
[Sensor]: Various telemetry sensors setting
[Telemetry]: Displays various data sent from the receiver
[Tele.setting]: Telemetry data log
[Trainer]: Starts and sets the trainer system.
>:DUQLQJVHWWLQJ@0L[LQJWKURWWOHSRVLWLRQZDUQLQJUHVHW
[User menu setting]: Original menu making
>'DWHUHVHW@0RGHOPHPRU\VHWGDWDUHVHWE\LWHP
LINKAGE MENU