FUTABA 16SZ - Page 73

74
＜ Linkagemenu ＞
Servospeed
6HWVWKHVSHHGRIHDFKVHUYR
The Servo speed setting is used to set the servo
delay for each channel, from channel l to channel
7KHV\VWHPXVHVWKHSURJUDPPHGVSHHGGHOD\
to slow down servo position changes. The Servo
Servo speed setting
7DSWKHVSHHGEXWWRQRIWKHFKDQQHO\RX
ZDQWWRVHW
8VHWKHYDOXHLQSXWEXWWRQVWRDGMXVWWKH
VHUYRVSHHG
ŏ,QLWLDOYDOXH
ŏ$GMXVWPHQWUDQJHaVWHSV
VSHHGVHWWLQJFDQEHYDULHGIURPWRLQHDFK
channel.
ŏ7DSWKH>6HUYRVSHHG@EXWWRQLQWKH/LQNDJH
PHQXWRFDOOWKHVHWXSVFUHHQVKRZQEHORZ
5HSHDWWKLVSURFHGXUHIRUHDFKFKDQQHO
7RFORVHWKLVVFUHHQWDSWKH>6HUYRVSHHG@
EXWWRQ
ŏ7DSWKH>6XEWULP@EXWWRQLQWKH/LQNDJHPHQXWR
FDOOWKHVHWXSVFUHHQVKRZQEHORZ
Sub-trim
6HWWLQJRIQHXWUDOSRVLWLRQRIHDFKVHUYR
The Sub-Trim function is used to set the servo
neutral position, and may be used to make fine
adjustments to the control surface after linkages
Sub-trim adjustment
7DSWKHWULPGLVSOD\SDUWRIWKHFKDQQHO\RX
ZDQWWRDGMXVW
9DOXHLQSXWEXWWRQVDSSHDUVRQWKH6XEWULP
PHQXVFUHHQ
and pushrods are hooked up. When you begin to set
up a model, be sure that the digital trims are set to
their center position.
8VHWKHYDOXHLQSXWEXWWRQVWRDGMXVWWKHVXE
WULP
ŏ,QLWLDOYDOXH
ŏ$GMXVWPHQWUDQJHaVWHSV
*See above
5HSHDWWKLVVWHSIRUHDFKFKDQQHO
ŏ5HWXUQWR/LQNDJHPHQX
ŏ5HWXUQWR/LQNDJHPHQX
（First）0〜27（Slowly）