FUTABA 16SZ - Page 98

99
＜ Linkagemenu ＞
rpm
Setstherpmonwhich
thealarmoperates.
↑Anupwardarrow
willshowthatanalarm
willsoundwhenthe
rpmrisesabovetheset
value.
↓Adownwardarrow
willshowthatanalarm
willsoundwhenthe
rpmfallsbelowtheset
value.
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
AllowsSpeechtobe
turnedONorOFF.
ŏ7DSWKH>USPVHQVRU@EXWWRQLQWKH7HOHPHWU\VFUHHQ
WRFDOOWKHVHWXSVFUHHQVKRZQEHORZ
Max.andmin.values
sincethepower
wasturnedONwill
display.
,WFDQQRWEHXVHGLQ)$667PRGHDQG6)+66PRGH
*Only receiver voltage and EXT voltage can be used in
)$667HVW&+PRGH
7KH)$667HVW&+7)+66PRGHFDQXVHDOOWKHWHOHPHWU\
functions.
Type1
Type2
Type3
"Vibrator"type
Ifthefollowingtypesareselected,thetransmitter
willvibrateduringthewarning.
Telemetry:RPMSensor
'LVSOD\LQJGDWDIURPWKHUSP
The RPM Sensor screen is used to set up an
optional rpm sensor and display the rotation
information it transmits.
7KHURWDWLRQRIWKHPRGHOHQJLQHPRWRUHWF
ZKLFKLVÀ\LQJFDQEHVKRZQ
If it becomes higher or lower than the setting, an
alarm and/or vibration will alert you.
Alarm set : Over
(
Under
)
rotations
7DS$ODUPDQGFKRRVHIURP%X]]HU9RLFH
DQG,QKLELW
&KRRVH,QKLELWIRU9LEUDWRULIQR
t
XVLQJWKH
YLEUDWRUDODUP,IXVLQJYLEUDWRUFKRRVHRQH
RIWKHWKUHHW\SHV
7DSWRWKH/LPLW>
xxx
USP@LWHP
$GMXVWWKHUDWHXVLQJWKHʈʈʈʆʆʆ
EXWWRQV
 ,QLWLDOYDOXHŃUSPŅUSP
 $GMXVWPHQWUDQJHUSPaUSP
Ń/LPLW
≧
Ņ/LPLW
*When the screen is tapped for one second, the rate is reset
to the initial value.
7RWHUPLQDWHWKHLQSXWDQGUHWXUQWRWKH
RULJLQDOVWDWHSXVKWKH+20((;,7EXWWRQ
*Anrpmsensormustbeinstalledintheaircraft.
"Magnet"
"Optics"
"Brushlessmotor"
SBS-01RM→
SBS-01RO →
SBS-01RB→
Gearratio
Blade
Pole
1.00~99.00
2~10
2~30
ŏ5HWXUQWR
/LQNDJHPHQX