84
SWH. DETAIL screen 5/7
From 4/7
Go to 6/7 from any cursor position
(12) ELE High / ELE Low: Linkage compensation elevator
At both the HIGH pitch and LOW pitch check to make sure that the swash
plate is staying level on the aileron and collective axis when using eleva-
tor inputs. If the swash plate is rising or falling, use the [
/+] or [ /-] key
to maintain the swash plate position the same as it is in the middle during
elevator inputs. Note: check all four directions: high/back; high/forward;
low/back; low/forward.
Setting ranges: 0 ~ 100% Initial value: 0%
(13) ELE Dir: Compensation direction of the elevator
If the above Data (+/-) correction from 0-100 is NOT in the correct com-
pensation direction, change the value from [+] or [-] using the [
/+] or [ /-]
key.
Setting: +/- Initial setting: +
To Next Page
Loading...
