103
Go to the menu title of SBUS SERVO screen 1/4
The following can be displayed and set only when the type setting is "OLP".
(15) Trq
This is the torque for working OLP.
Setting: 10% - 100% Initial setting: 100%
100% is the maximum torque of the servo which you are setting.
(16) TIME
This is the time for working OLP. Set the time when OLP (Over
Protection) functions. Displayed only when the type is OLP setting.
Setting: 0.2, 0.5, 1, 2, 3
sec, 4, 5, 6, 7, 8, 9, 10, 15, 20, 25, 30
sec
Initial setting: 5
sec
Note: If the setting of OLP torque and time is decreased, it is easier to
work OLP. Then, please be careful not to work OLP at usual operation.
The changeable S. BUS servo of 760
μS and 1520
μS
HPS-H700 / HPS-HC700
(As of February 2020)
To Next Page
Loading...
