48
(5) Servo Dir #: Servo direction #
Using different servo combinations will create the proper swash plate
servo movement in electronic CCPM models (eCCPM). In the H3-
xx swash mode, three of the swash servos directions are changed by
pressing the [
/+] or [ /-] key. Choose the combination number which
produces level swash plate travel with a collective pitch input from
the transmitter. There are 8 combination choices for the H3-xx swash
mode. On H4-xx swash mode, there are 16 combination choices. Af-
ter selecting the combination number, aileron, elevator, pitch, and 2nd
elevator servo parameters are automatically set.
Note: Occasionally the aileron or elevator function directions are re-
versed even though collective pitch direction is correct. In this case, use
the "SWS.Dir parameter on the following screen (3/5) to fix this later.
From 1/5
H1 or H3 SWH. BASIC screen 2/5 H4
Go to 3/5 from any cursor position
ELE2 is displayed only when
the swash type is H4-xx
(6)AIL, ELE, PIT. Ntr:
Servo neutral adjustment
Use the [ /+] or [ /-] key to adjust the neutral position
of the swash servo (aileron, elevator, pitch, second el-
evator). The second elevator (ELE2) is displayed only
when the swash type is H4-xx.
Setting ranges: +240 ~ -240 Initial value: 0
To Next Page
Loading...
