58
RUD. BASIC screen 1/2
(1) Servo Type
Select the appropriate setting for the tail rotor servo. Move the cursor
to "Servo Type" by pressing the [
/+] or [ /-] key and press the [Enter]
key to enter the setting mode. Then select the servo types: DG1520,
DG760 or Analog with the [
/+] or [ /-] key.
When "EXECUTE: Enter (1
sec)" is displayed, press the [Enter] key for about 1
second to changes
the selected type and exits the setting mode.
Setting: Analog / DG:1520 / DG760
Initial setting: DG:1520
DG 1520: BLS254, BLS257, S9254, S9257
DG 760: BLS276SV, BLS251SB, BLS251, S9256, S9251
WARNING
The servo type parameter within the CGY must
match the type of servo you are using. Incorrect
settings may damage the CGY or the servo. An in
-
correct setting may also result in a loss of control
during flight.
From 2/2 From the "Work Mode." of
RUD. BASIC screen 2/2
Go to 2/2 from any
cursor position
(2) Gyro. Dir: Gyro direction
This parameter controls which direction the CGY (yaw axis) will com-
pensate when the helicopter rotates. Hold the tail rotor linkage over
the linkage ball on the servo, pick the helicopter up by the main shaft
and rotate the mechanics counter-clockwise. The CGY should com-
pensate by adding clockwise rotation pitch to the tail rotor blades. If
the CGY compensates by adding counter-clockwise rotation pitch to
the tail rotor blades, then it will be necessary to reverse the Compen-
sation Direction setting by pressing the [
/+] or [ /-] key.
Setting value: Normal / Reverse Initial value: Normal
3D
: :
:
To Next Page
Loading...
