FUTABA FX-36 - Page 4

◆ Speed sensor screen
◆ Alarm setting
A setup of the speed
on which the alarm
operates.
Alarm is chosen from
Buzzer, Voice, and
Inhibit.
The ON/OFF switch
of Speech is chosen.
Airspeed
↑ An upward arrow
indicates the alarm
will sound when the
speed reaches above
your set value.
↓ A downward arrow
indicates the alarm
will sound when the
speed reaches below
your set value.
Type 1
Type 2
Type 3
"Vibrator" type
If the following types are selected, the transmitter
will vibrate during the warning.
Max. and min. values
since the power
was turned ON will
display.
2. CRSF Protocol for TBS
The T18SZ/T16SZ/FX-36 has been made compatible with
the CRSF (TBS) protocol.
■
Bidirectional communication function of CRSF is not
supported.
Futaba is not responsible for damage sustained by
combination with parts other than Futaba Genuine
equipment.
① [Linkage menu] → [System Type] → [Page 2/2] is
opened from the transmitter.
② Tap the "CRSF" button to [ON]. A signal conforming
to the CRSF standard is output from the S.BUS setting
connector (S.I/F) of the transmitter.
■
When using CRSF, the S.BUS servo setting
function and [Reload] [Register] [Change slot]
functions cannot be used. When setting S.BUS
servo and sensor, set CRSF to INH.
Tapping this will change
INH to ON and activated.