Need help?Do you have a question about the FUTABA FX10 and is the answer not in the manual?
General| Brand | FUTABA |
|---|---|
| Model | FX10 |
| Category | Remote Control |
| Language | English |
Details required 2-channel radio system, BEC compatibility, and transmitter types.
Explains need for 7.2v/1200mAH Ni-Cd packs and charging requirements.
Lists essential tools like screwdrivers, cutters, pliers, hobby knife, tweezers, and scissors.
Specifies paint types for the body shell and chassis/figure.
Covers initial steps like transmitter batteries, antenna extension, and system switch-on.
Details installation of steering servo and servo saver using specific parts and screws.
Explains mounting the throttle servo and connecting the speed control unit.
Describes attaching front/rear body mounts, shock tower, and battery compartment components.
Details assembling steering rods and mounting the servo to the chassis.
Covers mounting the speed controller and routing its wiring.
Guides installation of suspension arms, kingpins, uprights, and dampers with springs.
Instructions for attaching the front bumper using screws and ball joints.
Details assembly of the gearbox, including idler gear, bearings, and differential components.
Instructions for mounting the motor, pinion gear, and inspection cap to the gearbox.
Guides mounting the assembled gearbox to the chassis.
Explains attaching rear suspension components and connecting motor wires.
Details the assembly and installation of the rear dampers and coil springs.
Covers securing the receiver to the chassis and routing the antenna wire.
Instructions for mounting the receiver switch, harness, and rear wing.
Guides stretching tires onto wheels and mounting wheels to the axles.
Steps for connecting the battery and speed controller and securing the battery compartment.
Explains how to adjust steering linkage and upright angles for proper alignment.
Details checking and adjusting the speed control wiper arm movement.
Notes on using the MC112B ESC and connecting motor wires.
Instructions for trimming and drilling holes in the polycarbonate body shell.
Guides assembly and painting of the driver figure.
Instructions for mounting the assembled body shell onto the chassis.
Details applying decals to the body shell using liquid cleaner for positioning.
Essential pre-run checks for radio system and car components before actual operation.
Advice on battery discharge, re-checking controls, and basic driving techniques.
Lists common problems like burned resistors, motor issues, erratic throttle, and steering problems.
Lists components found in Parts Bag A.
Lists components found in Parts Bag B.
Lists components found in Parts Bag C.
Lists components found in Parts Bag D.
Details front and rear wheels and their components.
Lists items included in the small metal parts box.
Lists items included in the metal parts bag.
Lists components included in the spare body set.
Lists components found in Parts Bag E.
Lists screws and nuts included in Screw Bag A.
Lists screws and nuts included in Screw Bag B.
Lists screws, kingpins, and shafts included in Screw Bag C.
Lists various screws, nuts, and bearings included in Screw Bag D.
Lists components included in the Speed Controller Bag.
Lists gears and bearings included in the Gear Bag.
Provides a list of available spare parts sets by their part numbers.
To Next Page
