Need help?Do you have a question about the FUTABA FP-7UAF and is the answer not in the manual?
General| Brand | FUTABA |
|---|---|
| Model | FP-7UAF |
| Category | Remote Control |
| Language | English |
Describes PCM and FM system capabilities for high performance.
Details the RF module component of the transmitter and its function.
Covers display modes, liquid crystal panel, and edit keys.
Includes set data retention and complete mixing functions.
Lists specifications for included transmitter and receiver units.
Details servo models and battery pack specifications.
Lists included accessories and FM crystal sets for frequency selection.
Instructions for charging the transmitter and receiver Nicd batteries.
Explains the factory default modulation system.
Guide to changing the transmitter Nicd battery pack.
Steps for replacing the RF module to change frequency.
Diagram and guide for connecting receiver and servos.
Important safety and operational guidelines for using the system.
Guidance on selecting and using servo horn mounting screws.
Covers proper installation and performing a range check.
Details the information displayed in normal operation.
Explains the function of MODE SELECT, EDIT KEY, CURSOR, and DATA INPUT buttons.
Describes the function data setting display mode.
Explains LOW BATTERY and BACK-UP error displays.
Adjusts servo throw for left/right or up/down.
Modifies servo operation curve for smoother control.
Used to change the direction of servo operation.
Sets servo position during reception loss.
Mixes two channels for aircraft control enhancement.
Allows mixing of any two channels for improved operation.
Mixes elevator input to control flap movement.
Mixes flap input to control elevator movement for air brakes.
Enables snap rolls on any of four directions via switch.
Applies differential to ailerons for roll axis correction.
Gives ailerons a flap function for simultaneous raising/lowering.
Adjusts flap trim and sub trim for precise control.
Combines D/R switch functions into three selectable modes.
Switches between PCM and PPM transmission modes.
Covers lever adjustments and receiver battery fail-safe function.
Explains how to use the trainer function with a trainer cable.
Describes splined horns for adjusting servo neutral position.
Details frequency bands and channel allocations for USA.
Instructions for attaching and using the antenna frequency flag.
Lists colors for frequency channel number flags.
Diagram and list identifying transmitter parts.
Exploded view and part list for FP-S148 servo.
Exploded view and part list for FP-S3001 servo.
To Next Page