FUTABA FP-7UAF - Modulation (MOD); Lever Adjustment and B.F;S

• FUNCTION AND DATA SETTING
• OTHER FUNCTIONS
Press the [MODE SELECT]
To normal display mode
Mode selection
MOD
MODULATION
The modulation can be switched
PCM <-> PPM mode.
* Select the PCM mode for the FP-
7UAP and the PPM mode for the
FP.7UAF.
*When using the trainer function.
select the same mode at the in-
structor side and student side
transmitters.
When the mode is changed, the
display flashes.
The actual transmit output at
that time is the mode before the
change.
*When the mode was switched, the transmit-
ter power switch is turned off and transmit
output is obtained the next time the trans-
mitter power switch is turned on.
Select the mode with
the
keys.
C:PCM
F:PPM
ToATV
• Non-slip adjustable lever head adjustment
• Stick lever tension adjustment
1 Remove the transmitter back cover.
Remove the four
screws and remove
the back cover.
The length of the lever head can be changed.
Lever head
Lever head
Unlock lever heads
and
by turning them in
opposite directions as shown by the arrows and
adjust the stick to the most comfortable length.
• Receiver B.F/S function
When the receiver battery voltage drops below a
certain value, the throttle servo moves to a preset
position. (B.F/S mode)
At this time, reset the B.F/S mode and immedi-
ately land the aircraft.
2 Adjust the spring strength.
Set to the desired spring
Strength by turning the
screw of each stick.
Elevator
Aileron
Rudder
Use a small Phillips
screwdriver.
1 B.F/S mode position setting
• Set the throttle channel (CH3) to the F/S
function.
Settinq method
•The set position should be close to maxi-
mum slow.
2 B.F/S mode resetting method
Throttle stick
•When the throttle stick
is set to the maximun
slow position, the B.F/S
mode is reset.
— 19—