FUTABA FP-7UAF - Exponential (EXP) Function; Reverse (REV) Function

• FUNCTION AND DATA SETTING
To REV
To F/S
Function
Display Data setting
CH selection
Select the CH to which EXP is
to be applied with the
keys.
EXP
EXPONENTIAL
This function modifies the operat-
ing curve so that operation is easy
when the movement of the servos
becomes sluggish or sensitive near
the neutral position.
•EXP can be set for CH1 (aileron),
CH2 (elevator), CH3 (throttle),
and CH4 (rudder).
• The rate can be set for each direc-
tion of the
(However, there is no
for the throttle.)
•The rate setting range is —100%
(slow side) to +100% (quick side)
in 4% steps.
D/R switch direction selection
Switch to the direction to which
the
is to be set.
Rate setting
Set the rate with the
keys. (When the + and
- keys are pressed simultaneous-
ly, 0% is set.)
Set for a different CH and
direction by repeating steps
(Note) At initial flight, test at EXP 0%. Ad-
justment as desired in accordance with flight
is recommended.
Function
Display
Data setting
REV
REVERSE
Used when modifying servo direc-
tion of operation.
• Can be set for each channel.
N: Normal side
R: Reverse side
CH selection
Select the CH for which REV is
to be set with the
keys. (CH NO. flashes)
Direction of operation setting
Set the direction with the
keys.
+ : Normal
—: Reverse
Set for another channel by repeating steps
and
(Note) Be especially careful in the aileron
direction.
Press the [MODE SELECT]
To normal display mode
-9-