• FUNCTION AND DATA SETTING
Set for a different CH and
direction by repeating steps
to
Set the rate with the
keys. (When the + and
— keys are pressed simultaneous-
ly.
100%
is
set.)
•Related function COMBINATION
SWITCH.
• D/R can be set for CH1 (aileron),
CH2 (elevator), and CH4 (rud-
der).
• D/R can be set for each direction
of
the
With this feature you can select
which switch position you want
for high rate and low rate.
• The rate setting range is 30% to
110%.
The rate can be switched with the
Switch to the direction for
which the
is
to
be
set.
D/R switch direction selection
Select the CH for which D/R is
to be set with the
keys.
To D/R
Set for a different CH and direction by re-
peating steps
Set the rate with the
keys. (When the + and
— keys are pressed simultaneous-
ly,
100%
is
set.)
The rate described below is set
, or
Select the Direction with the
R/U: Right or up
L/D: Left or down
• The rate can be set for each chan-
nel.
• The left and right (up, down) rate
can
be
set.
• The rate setting range is 30% to
110%.
This function adjusts the servo left
and right throws and is used in
linkage correction.
Select the CH to which ATV is
to be applied with the
keys.
CH selection
Direction selection
Rate setting
ATV
ADJUSTABLE TRAVEL
VOLUME
Press the [MODE
SELECT]
To normal display mod*
Function
Display
Data setting
8
To Next Page
Loading...
