• FUNCTION AND DATA SETTING
Press
the [MODE SELECT]
To normal display mode
Activate/inhibit mode setting
Set the mode with the
keys.
+ : Activate
-: Inhibit
Select the direction
Switch
the
RIGHT
UP
DOWN
LEFT
to the combination
of directions to be set.
Aileron servo throw setting
Set the flashing display
to CH1
with the
keys.
Set the rate with the
keys.
(When the + and — keys are
pressed simultaneously, 100% is
set.)
Elevator servo throw setting
Set the same as
Rudder servo throw setting
Set the same as
Set for each direction of the
by repeating steps
to
SAFETY mode setting
Set
the
to CH5 with
the
keys.
Set
the
to
the
direction for which snap roll is
to be turned off (direction in
which landing gear is down).
Press the — side of the
keys.
SAFETY mode release
Set
the
to CH5 with the
keys.
Press the + side of the
keys.
ToDIFF
F: SAFETY mode released
5L: SAFETY mode set and
ON
5F: SAFETY mode set and
OFF
SNAP ROLL
UP
RIGHT
LEFT
DOWN
"1" to "4" is displayed
according to the
position.
1:
R/U
2:
R/D
3:
L/U
4:
L/D
• The SAFETY mode can be set.
(Mode in which operation is not
performed when the landing gear
is down even if the switch is turn-
ed on by mistake.)
• The throw of the channel 1 (ail-
eron), channel 2 (elevator), and
channel 4 (rudder) servos can be
set.
• Four snap roll directions can be
set.
R/U: Right up snap
R/D: Right down snap
L/U: Left up snap
L/D: Left down snap
(INH: Inhibit state)
SNP
SNAP-ROLL
Avalanche and other snap rolls can
be performed by switch.
-
15
—
To Next Page
Loading...
