FUTABA GYA553 - S.BUS Basic Menu; S.BUS Function Assignments; Rate Switching Channel Setup; Auto Recovery Settings

10
SBUSBasicmenu
SBUSBasicmenu
WARNING
AlwaysverifythattheS.BUSfunctionassignments
matchyourtransmitterʼ sfunction(intheFUNCTION
menu)assignments.Ifanychangesaremadewithin
thetransmitterfunctionassignments,thenitwillalso
benecessarytomakethechangeswithintheS.BUS
functionassignments.Tochangethechannel,GYA553
andT16IZmustbeconnected.
The channel of each function can be changed.
ON-OFFchannelforauto
recovery
ReseteachS.BUSfunction.It
returnstotheinitialvalue.
!10CHON
Set the CH for each function according to the transmitter to be used. Any unused functions should be set
to INH (Inhibited).
HoldingPowerC2toC5
TaptheCHusedforrateswitching
toselectit.
Taptomovetotherate
switchingCHsettingpage.