6
Measuring
Single distance measurement
Press to activate the laser. Press again to trigger the distance measurement.
The result is displayed immediately.
Minimum/maximum measurement
This function allows the user to measure the minimum of maximum distance from a
used to measure room diagonals (maximum values) or horizontal distances (mini-
mum values).
Press the -button and hold down this button until you hear a beep. Then slowly
sweep the laser back and forth and up and down over the desired target point (e.g.
into the corner of a room).
Press the -button to stop continuous measurement. The values for maximum and
minimum distances are shown in the display as well as the last measured value in the
summary line.
Addition / Substraction
Push the to do a distance measuring
Use the -button to add a measurement to the previous one.
This process van be repeated as required.
Use the -button to substract a measurement to the previous one.
This process van be repeated as required.
Use the -button to cancel the last step.
To Next Page
Loading...
Need help?
General
