Futech FT004D-USB-BT - Audio Mode and Volume Settings; Set Audio Mode Memory; Set Resume Volume Type; Set Auto Gain

To Previous Page

2.4 HOW TO SET AUDIO MODE MEMORY

you can able to disable user set audio mod memory feature by

Advanced setting -> System setting -> General set -> Mode Lock = yes

note :

Audio mode memory setting 2 type of method available.

2. Advanced setting -> Audio setup -> Modes Level expert set by .

1. user can be set audio mod memory by hold ( mod 1 , mod2 , mod 3 ) button to memory

2.5 HOW TO SET RESUME VOLUME TYPE

you can set resume type by

Advanced Setting -> Audio Setting -> General Set -> Boot Volm

Resume volume set 3 type available

3. = Resume last Mode ( mod1 , mod2, mod3 ) volume . MODE

1. = Resume last adjusted volume. RESM

2. = Resume default reset volume DFLT

FT004D-USB-BT

5.1Ch Remote Control Kit

User’s manual

2.7 HOW TO SET BOOT STBY MODE

Advanced Setting -> System Setting -> General Set -> Boot St-by = YES

if you want poweron device will go standby mode set by

1. = Standby mode enabled. YES

2. = Standby mode disabled. NO

1. = User mode lock enabled. YES

2. = User mode lock disabled. NO

2.6 HOW TO SET AUTO GAIN

you can enable/disable auto gain mode

Advanced Setting -> Audio Setting -> General Set -> Auto Gain

Auto Gain is working principle in simple.

((47dB attenuation + 7dB Gain) 50dB Volume * 2dB per Step = Total 100dB ) ,

Once auto gain enabled , input gain not possible to set.