5. Close the left and right bottom compartment plate of the middle
compartment and feed the bait. When the middle compartment door is
remotely opened, the warning indicator will flicker.
6. After turning on the boat switch, the front and rear lights of the boat will
flicker three times, test the functions of the remote controller. If it is
normal, place the boat into the water and begin to use it.
7. If a rear explosion hook hopper is required, you can put explosive bait or
a hook in it, please note that the fishing line should go through the
reserved wiring slot. Each time when the hopper door is opened, it is
accompanied by flickering of the indicator.
8. If a hook device is required, please operate the left rocker of the remote
controller downward to open the hook device and place the hanging ring
of the fishing line. When the hook device is remotely opened, the
indicator light will flicker.
9. After use, please turn off the switch of the remote controller and the boat.
2. Operation instruction of remote controller
The standard remote controller is operated as follows:
Operation instruction of standard remote controller:
1. Control opening of the bait hopper and hook device by using the left rocker
of the remote controller. Dial left to open the left bait hopper of the middle
compartment, dial right to open the right bait hopper of the middle
compartment, dial up to open the right tail hopper, and dial down to open
To Next Page
Loading...
