IV. Operation guidance
1. Boat installation and operation instruction
The boat functions are described as follows:
Installation instruction:
1. First open the left and right battery compartment covers, take two
batteries from the foam box, place them into the left and right battery
compartment of the boat respectively, fix the batteries by using the
binding tapes, connect the battery power lines at two ends and close the
left and right battery compartment cover.
2. Take out the boat antenna, fasten it clockwise, and fix it onto the boat
antenna seat.
3. If nesting is required on the left and right side of the middle
compartment, insert the division plate of the middle compartment into the
front and rear slot of the compartment and fix it.
4. To use the remote controller, place four AA-sized batteries, return all the
rockers of the remote controllers to the origin and turn on the remote
controller switch. The power indicator of the remote controller will be
on.
To Next Page
Loading...
