1. Connect servo extension leads to the
elevator and rudder servo cables.
2. Install the elevator and rudder servos
into the airframe.
3. Feed the elevator and rudder servo
cables through the inside of the fuselage.
4. Locate the landing gear and landing
gear plate.
5. Insert the landing gear and landing gear
plate into the landing gear slot in the
fuselage and use thin CA glue to secure.
6. Carefully insert the wing into the fuselage.
Measure to ensure that both the front and
the rear of the wing are evenly spaced on
both sides of the fuselage.
To Next Page
Loading...